news

  • Basic knowledge of elevators - common terms for elevators

    Basic knowledge of elevators - common terms for elevators

    (1) Increase the height. Refers to the total operating height of the elevator from the bottom end station to the top end station floor. (2) landing. In each floor, where the elevator stops, there is at most one station for each floor, but there are no stations on certain floors as needed. (3) The bottom end station. Refers to the lowest stop of the building's small elevator. When the building has an underground floor, the bottom end station is often not the bottom station of the building. (4) To... read more

    Jan 26,2019 News
  • The basic knowledge of the elevator - the type of elevator and the main parameters

    The basic knowledge of the elevator - the type of elevator and the main parameters

    Rated load and theoretical transport capacity (1) Rated load. The rated load is the main parameter of the elevator and refers to the elevator load specified in the design. Generally, it can be divided into different grades such as 100kg, 200kg, 320kg, 400kg, 630kg, 800kg, 1000kg, 1250kg, 1000kg, 2000kg, 2500kg, 3000kg, 5000kg. Among them: the debris elevator has a weight limit of less than 200kg; The weight series of the passenger ladder is: 630kg, 800kg, 1000kg, 1250kg, 1600kg; The weight serie... read more

    Feb 01,2019 News
  • The elevator is divided according to control(1)

    The elevator is divided according to control(1)

    The elevator is divided according to control(1) (1) The handle switch controls the elevator. It refers to the elevator driver who turns the handle position (open/close) to operate the elevator running or stopping. This kind of elevator is rarely seen. (2) The button controls the elevator. The button controls the elevator's running inner station call button to operate. A certain station will press the call button to the factory, and the elevator will start running to answer. In the elevator runni... read more

    Feb 11,2019 News
  • The elevator is divided according to control(2)

    The elevator is divided according to control(2)

    (4) Collecting and controlling elevators. The collective control elevator collects the call signals on the basis of signal control for selective response. The elevator is operated without a driver. During the operation of the elevator, it can automatically answer all the landing call signals in one direction. After the elevator runs for one week, if there is no call signal, it will stop at the base station for standby. In order to adapt to this control feature, the car door is provided with a do... read more

    Feb 20,2019 News
  • Measurement of elevators and escalator shafts (3)

    Measurement of elevators and escalator shafts (3)

    Sixth, the basic content of the escalator hoistway measurement 1. Measure the lift height. It is the same as the height of the measuring straight ladder. Strictly speaking, the lifting height of the escalator is the vertical distance between the upper and lower supporting beams at the finished ground. When measuring with the hanging line method, pay attention to the falling point and the lower support of the escalator. There is no gap between the beam decoration surfaces. 2. The beam margin betw... read more

    Feb 28,2019 News